Display: Finisher Failure #. Turn off then on, after checking finisher
Description: Front Jogger operation is abnormal.
Remedy: 1) Is the Front Jogger Home sensor (S6) working? a) Check if the Front Jogger home sensor actuator(SJ10 3318) is abnormality. b) Check if the connector(SJ10 8310) of Front Jogger home sensor(S6) is disconnected. c) Check if the connector(SJ10 8310) J8 on the finisher main board(JC81-07242A) is disconnected. d) Check for continuity in the wire harness and whether the harness is damaged(SJ10 8310), replace it if required. e) Replace the Front Jogger home sensor(S6). f) Replace the Finisher main board(JC81-07242A). 2) Is the Front Jogger motor (M5) working? a) Check if the connector (SJ10 8310)of Front Jogger motor(M5) is disconnected. b) Check if the connector (SJ10 8310) J6 on the finisher main board(JC81-07242A) is disconnected. c) Check for continuity in the wire harness and whether the harness is damaged(SJ10 8310) , replace it if required. d) Replace the Front Jogger motor(M5). e) Replace the Finisher main board(JC81-07242A). 3) Is there any belt(gear) jumping noise? a) Check if the Front Jogger driving belt(JC81-03509A) is assembled correctly. b) Check if the Front Jogger driving belt(JC81-03509A) is broken. Replace the belt if it does. c) Check if the Front Jogger motor bracket(SJ10 3206) is fasten on tamper base(JR10 3304) by screw. d) Check if the tooth of gear(SJ10 3308) is broken. Replace the gear if it does. e) Check if the Front Jogger shaft(JR10 3304) became pollution. Remove if it does. 4) Replace the Front Jogger Unit(JC81-03511C).