Display: Finisher Failure #. Turn off then on, after checking finisher
Description: Rear Jogger operation is abnormal.
Remedy: 1) Is the Rear Jogger Home sensor (S5) working? a) Check if the Rear Jogger home sensor actuator(SJ10 3318) is abnormality. b) Check if the connector(JR10 8320) of Rear Jogger home sensor(S5) is disconnected. c) Check if the connector(JR10 8320) J7 on the finisher main board(JC81-07242A) is disconnected. d) Check for continuity in the wire harness and whether the harness is damaged(JR10 8320), replace it if required. e) Replace the Rear Jogger home sensor(S5). f) Replace the Finisher main board(JC81-07242A). 2) Is the Rear Jogger motor (M4) working? a) Check if the connector(JR10 8320) of Rear Jogger motor is disconnected. b) Check if the connector(JR10 8320) J5 on the finisher main board(JC81-07242A) is disconnected. c) Check for continuity in the wire harness and whether the harness is damaged(JR10 8320), replace it if required. d) Replace the Rear Jogger motor(M4). e) Replace the Finisher main board(JC81-07242A). 3) Is there any belt(gear) jumping noise? a) Check if the Rear Jogger driving belt(JC81-03509A) is assembled correctly. b) Check if the Rear Jogger driving belt(JC81-03509A) is broken. Replace the belt if it does. c) Check if the Rear Jogger motor bracket(SJ10 3206) is fasten on tamper base(JR10 3306) by screw. d) Check if the tooth of gear(SJ10 3308) is broken. Replace the gear if it does. e) Check if the Rear Jogger shaft(SJ10 3404) became pollution. Remove if it does. 4) Replace the Rear Jogger Unit(JC81-03507C).