Description: Sheet not leaving finisher paper path section.
Remedy: If the error still occurs, check the followings. 1) Check if the Finisher of the interface cable(JC81-03470A) should be connected with the IOT. a) Power of the IOT Off. b) IOT and Finisher of the interface cable(JC81-03470A) is connected. c) Power of the IOT On. 2) Is the LEDs of the Main Control Board (JC81-07242A) working? <Open the Bottom cover (SJ10 6160) of Finisher > a) The Finisher of the Door(JC63-03941A, JC81-07249B) should remain closed to all. b) Red, yellow color LED is ON, and Green LED flickers c) Replace the Finisher main control board(JC81-07242A). 3) Is the Finisher Entrance Sensor(S2) working? a) Check if the Entrance sensor actuator(SJ10 2384) is abnormality. b) Check if the connector (SJ10 8350)of Finisher entrance sensor(S2) is disconnected. c) Check if the connector(JR10 8320) J7 on the Finisher main board(JC81-07242A) is disconnected. d) Check for continuity in the wire harness and whether the harness is damaged(SJ10 8350, JR10 8320), replace it if required. e) Replace the Finisher input sensor(S2). f) Replace the Finisher main control board(JC81-07242A). 4) Is the Feed Entrance Motor (M1) working? a) Check if the connector(JR10 8320) of the Feed entrance motor is disconnected. b) Check if the connector(JR10 8320) J5 on the Finisher main board(JC81-07242A) is disconnected. c) Check for continuity in the wire harness and whether the harness is damaged(JR10 8320), replace it if required. d) Replace the Feed entrance motor(M1). e) Replace the Finisher main control board(JC81-07242A). 5) Check if there is any object on finisher paper path. Remove it if there is.