Description: Sheet jam on finisher paper path section
Remedy: Check if there is any paper on the finisher, the IOT paper path. Remove it if there is. If the error still occurs, check the followings. 1) Is the Finisher Entrance Sensor(S2) working? a) Check if the Entrance sensor actuator(SJ10 2384) is abnormality. b) Check if the connector(SJ10 8350) of Finisher entrance sensor(S2) is disconnected. c) Check if the connector(JR10 8320) J7 on the Finisher main board(JC81-07242A) is disconnected. d) Check for continuity in the wire harness and whether the harness is damaged(JR10 8320, SJ10 8350), replace it if required. e) Replace the Finisher entrance sensor(S2). f) Replace the Finisher main control board(JC81-07242A). 2) Is the Feed Entrance Motor (M1) working? a) Check if the connector(JR10 8320) of the Feed entrance motor is disconnected. b) Check if the connector(JR10 8320) J5 on the Finisher main board(JC81-07242A) is disconnected. c) Check for continuity in the wire harness and whether the harness is damaged(JR10 8320), replace it if required. d) Replace the Feed entrance motor(M1). e) Replace the Finisher main control board(JC81-07242A). 3) Is the Finisher Exit Sensor (S3,S11) working? a) Check if the Exit sensor actuator (SJ10 2384) is abnormality. b) Check if the connector(SJ10 8340) of the Finisher Exit sensor(S3) is disconnected. c) Check if the connector(JR10 8320) J7 on the Finisher main board(JC81-07242A) is disconnected. d) Check for continuity in the wire harness and whether the harness is damaged(JR10 8320, SJ10 8340), replace it if required. e) Replace the Finisher exit sensor(S3,S11). f) Replace the Finisher main control board(JC81-07242A). 4) Is the Feed Exit Motor(M2) working? a) Check if the connector(JR10 8320) of the Feed exit motor is disconnected. b) Check if the connector J5 on the finisher main board(JC81-07242A) is disconnected. c) Check for continuity in the wire harness and whether the harness is damaged(JR10 8320), replace it if required. d) Replace the Feed exit motor(M2). e) Replace the Finisher main control board(JC81-07242A). 5) Check if there is any object on finisher paper path. Remove it if there is.