Display: Too much paper in finisher stacker. Remove printed paper.
Description: Finisher output tray is full.
Remedy: 1) Remove paper from the finisher main tray. Main tray will move downward and upward to clear stack full warning. 2) If warning does not disappear, follow the instructions below : a) Does finisher main tray input sensor (Standby & Home sensor) work well? i) Make sure finisher input sensor cable is connected well to the sensor connector. ii) Make sure finisher input sensor cable is connected well to the main board connector. iii) Replace the finisher input sensor(JC81-09686A). iv) Replace the finisher main board(JC81-09692A). b) Does finisher main tray motor work well? i) Make sure finisher main tray motor cable is connected well to the main tray motor connector. ii) Make sure finisher main tray motor cable is connected well to the main board connector. iii) Replace the finisher main tray motor(JC81-09679A). iv) Replace the finisher main board(JC81-09692A). c) Check if any debris (staple) is present. Please make sure to remove any debris.