Code: 1-090
Description: Ghost occurs at 94mm intervals
Causes: 1. Developer cartridge 2. Main body. 1. Contamination of high voltage terminals in the main body, engine board, and/or developer. 2. Transfer roller lifetime has expired. 3. No using recommended recording paper. 4. The erasing lamp defective.
Remedy: 1. Open top cover and disassemble the unit and clean contamination components. 2. After replacing the transfer roller, make sure the transfer voltage is normal. 3. Use a recommended type of recording paper. 4. If the erasing lamp does not turn on and off properly, check the lamp PCB and Q1/Q10 in the engine board. The erasing lamp should be on when CPU pin 35 is 0V. (Check the voltage by removing the developer and activating the top cover switch)