Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi 2-020 — Samsung ML85G

Code: 2-020

Description: 1. Recording paper does not feed into the printer. 2. Recording paper feeds, and ‘Jam 0’ occurs.
Causes: Engine board. 1. If the paper does not feed into the printer, the feed clutch driving circuit in the engine board may be defective. 2. If the paper feeds into the printer and ‘Jam 0’ occurs, the feed sensor OP1 on the engine board may be defective.
Remedy: 1. Check for the solenoid driving circuit using DCU diagnostic mode 06 a) Check for 24V on D1 cathode. If 24V is not present, check Q9. If Q9 is good, check Q6 and its related parts. If they work normally, check for 24V output from SMPS. b) Measure the feed clutch resistance. Replace if not approximately 60 ohms. c) Check Q4. If Q4 is OK, the collector and base should be 0V and 0.7V DC to GND, respectively. 2. Check Feed sensor OP1 and related parts. a) Replace Feed sensor actuator of defective. b) When OP1 sensor is blocked, CPU pin 46 should be over 3.5V. When sensor is not blocked, the pin should be below 0.7V. One side of R16 in OP1 transmitter should be 5V, and the other end 1.2V. If normal, check OP1 receiver. If not shorted, replace CPU.

← Xem tất cả mã lỗi Samsung ML85G

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie