Code: 3-010
Description: FUSER ERROR message displayed on the monitor screen.
Causes: 1. Fuser 2. Engine board. 1-1. Thermostat, AC wire, or heat lamp may be open. 1-2. Thermistor may be open.(Use DCU error code 60 and 62). 2-1. Abnormal heat lamp on/off 2-2. Malfunction of the overheat circuit
Remedy: 1-1. Check thermostat, AC wire, and heat lamp. If the thermostat is open, check also R34, R47, and Q8. 1-2. If thermistor is open, check the wire. If the wire is good, check Q8. Q8 collector should be 0.2V, base 0.7V. 2-1. Check Q3 and its related parts in the order shown below. (Q3 on, and 0V and 24V respectively with lamp off. 1) Check Q3 C-E, B-E, B-C, and replace if shorted. If the voltage between B and E is below 0.7V, replace. 2) When lamp is on, if the base is 0V, check CPU pin 38. 3) If collector is 0V and lamp not on, check PC151, Q101, and parts. 2-2. Check the overheat circuit. When U5 pin 7 is below 0.5V, the overheat circuit should activate and the lamp turns off. In normal mode, pin 6 is approximately 2.6V, pin 5 is over 2.6V, and pin 7 is over 4V. If not, check all related parts.