Code: H2-6736 ... H2-6743
Display: Finisher Failure: #H2-67xx. Check finisher
Description: Main Tray does not move to or leave home position.
Remedy: 1) If there is jammed paper on the Main Tray, removing paper manually. Open and close finisher stapler door or jam cover to check if finisher executes initialization process. 2) If Main Tray still doesn’t go back to home position and error does not disappear, follow the instructions below: a) Does finisher input sensor (Standby & Home sensor) work well? i) Make sure finisher input sensor cable is connected well to the sensor connector. ii) Make sure finisher input sensor cable is connected well to the main board connector. iii) Replace the finisher input sensor(JC81-09686A). iv) Replace the finisher main board(JC81-09692A). b) Does finisher Main Tray motor work well? i) Make sure finisher Main Tray motor cable is connected well to the motor connector. ii) Make sure finisher Main Tray motor cable is connected well to the main board connector. iii) Replace the finisher Main Tray motor(JC81-09679A). iv) Replace the finisher main board(JC81-09692A). b) Does finisher Main Tray motor work well? i) Make sure finisher Main Tray motor cable is connected well to the motor connector. ii) Make sure finisher Main Tray motor cable is connected well to the main board connector. iii) Replace the finisher Main Tray motor(JC81-09679A). iv) Replace the finisher main board(JC81-09692A). c) Do finisher Main Tray parts work well? i) Make sure Main Tray parts can move or rotate smoothly. ii) Make sure there are no mechanical interference to stop moving or rotating. iii) Make sure the belt is tight in the correct position, if it has a belt. d) Does finisher Main Tray motor gear set work well? i) Make sure gear set can rotate smoothly. ii) Make sure each gear is not broken. iii) Replace the gear set(JC81-9585A / JC81-09586A). e) Check if any debris is present. Please make sure to remove any debris.