Display: Staple Cartridge not install. Install it.
Description: Finisher stapler cartridge is not installed into stapler.
Remedy: 1) Open finisher stapler door to put cartridge into stapler and then close door. Self-Priming will be execute automatically if necessary. 2) If stapler warning does not disappear, follow the instructions below : a) Does finisher stapler input sensor work well? i) Make sure finisher input sensor cable is connected well to the sensor connector. ii) Make sure finisher input sensor cable is connected well to the main board connector. iii) Replace the finisher stapler cartridge(JC81-08653A). iv) Replace the finisher stapler(JC81-07376A). v) Replace the finisher main board(JC81-09692A). b) Check if any debris is present. Please make sure to remove any debris.