Description: Fusing warm-up trouble (Middle of the heating roller). Detected temperature of the thermistor/1 (TH1) or thermistor/2 (TH2) does not go up a given range of temperature even after a lapse of given period of time at warm up.
Causes: • Fusing unit • Thermistor/1 (TH1) • Thermistor/2 (TH2) • DC power supply (DCPU) • MFP board (MFPB)
Remedy: 1. Check the fusing unit for correct installation (whether it is secured in position). 2. Check the open/close operation of the right door. 3. Check the connector between the fusing unit-relay CN19-MFPB CN18E for proper connection and correct as necessary. 4. Check the connector between the fusing unit-relay CN7AC-DCPU CN2 for proper connection and correct as necessary. 5. Check the connector between MFPB CN2E-DCPU CN7 for proper connection and correct as necessary. 6. Replace the fusing unit. 7. Replace MFPB. 8. Replace DCPU.