Description: Slider over running. The scanner home sensor (PS105) detects the scanner at its home position during a period of time that begins with the time when a prescan command and a scan preparation command are executed and ends when a home return command is executed.
Causes: • Scanner home sensor (PS105) • Scanner motor (M101) • MFP board (MFPB)
Remedy: 1. Correct or change the scanner drive (pulley, gear, belt) if it is faulty. 2. Correct the scanner motor set screw if loose. 3. Adjust [Image Position: Leading Edge] and [Sub Scan Zoom Adj.]. 4. Check the connector between M101-relay CN6IR-MFPB CN26E for proper connection and correct as necessary. 5. Check the connector between PS105-MFPB CN27E for proper connection and correct as necessary. 6. PS105 I/O check, sensor check • Control signal: MFPB CN27E-15 (ON) • Location of electrical component: 5-V 7. M101 operation check • Control signal: MFPB CN26E-1 to 4 • Location of electrical component: 6-W 8. Replace MFPB.