Remedy: Step 1: 1. Make sure that the cable JFAN1 is properly connected to the controller board. 2. Check if the cooling fan is rotating properly. Is it rotating properly? Yes: Go to step 2. No: Replace the cooling fan.
Step 2: 1. Turn off the printer, and disconnect JFAN1 from the controller board. 2. Turn on the printer, and measure the voltage across JFAN1. Is the voltage approximately 24 V? Yes: Go to step 3. No: Replace the controller board.
Step 3: Is the fan idle? Yes: Replace the cooling fan. No: The problem is solved.