Description: Abnormally low toner density detected black TCR sensor. When sampling data is determined in TC ratio calculation control, TCR sensor output is higher than a predetermined value for a predetermined number of times in a row even though there is toner in the sub hopper
Causes: • Developing unit • Toner cartridge • Toner empty switch/K (PS31) • Toner bottle motor (M10) • Toner supply motor/K (M6) • Front side board (FRB) • Printer control board (PRCB)
Remedy: 1 Perform image troubleshooting procedure if image density is low. 2 Reinstall developing unit 3 Reinstall toner cartridge 4 Check the connector between developing unit-FRB CN13 for proper connection and correct as necessary. 5 Check the connector between FRB CN1, CN3-PRCB CN7, CN9 for proper connection and correct as necessary. 6 M10 operation check PRCB CN14-1 to 4 17-C 7 M6 operation check PRCB CN14-5 to 8 17-C 8 If the toner empty sensor and its surroundings inside the sub hopper are dirtied with toner, clean them. 9 Replace the developing unit 10 Replace FRB 11 PRCB IC44, IC46 conduction check 12 Replace PRCB