Code: C-2802
Description: The maximum density correction (Dmax) is not completed. While in Dmax, the number of rotations of the developing sleeve gets to the maximum.
Causes: • Developing motor (M3) • Toner control board (TCB) • Printer control board (PRCB)
Remedy: 1. Check TCB, and clean it with alcohol if there is IDC sensor dirt or any abnormality. (Wiring diagram: Main body (3/4): 18-I) Be sure to clean TCB with alcohol, otherwise replacement of TCB is required. 2. Check the connector connection and the wiring between PRCB and TCB, and repair it if any abnormality. 3. Check the I/O drive of the motor and the coupling of the gear, and clean/repair/replace it if any abnormality.(Wiring diagram: Main body (3/4): 16-P) 4. Replace TCB. 5. Replace M3. 6. Replace PRCB.