Description: Tray 4 lift-up failure (When PC-214 is installed) The tray 4 upper limit sensor (PS126) is not turned ON (blocked) even after the set period of time has elapsed after the paper lift-up operation for the drawer began.
Causes: • Tray 4 lift-up motor (M123) • Tray 4 upper limit sensor (PS126) • PC control board (PCCB) • MFP board (MFPB)
Remedy: 1. Remove the tray and check to see if a piece of paper is not left inside the machine. 2. Check the connector between M123-PCCB CN8C for proper connection and correct as necessary. 3. Check the connector of M123 for proper drive coupling and correct as necessary. 4. Check the connector between PS126-relay CN47-PCCB CN7C for proper connection and correct as necessary. 5. PS126 I/O check, sensor check • Control signal: PCCB CN7C-3 (ON) • Location of electrical component: PC-214 8-K 6. M123 operation check • Control signal: PCCB CN8C-8 to 9 • Location of electrical component: PC-214 5-K 7. Replace M123. 8. Replace PCCB. 9. MFPB F11E conduction check 10. Replace MFPB. NOTICE • Link to the wiring diagram (N.2.3 PC-214) • Link to the layout drawings for related parts by each trouble code (S.9. C0208)