Description: Paper discharge control motor malfunction (When FS-534SD is installed) The curl cover detection sensor (PS2) is not turned ON (blocked) or OFF (unblocked) even after the set period of time has elapsed after the paper discharge control motor (M2) is turned ON.
Causes: • Paper discharge control motor (M2) • Curl cover detection sensor (PS2) • SD drive board (SDDB) • FS control board (FSCB)
Remedy: 1. Check the connector between M2-relay CN3-relay CN2-SDDB J5 for proper connection and correct as necessary. 2. Check the connector of M2 for proper drive coupling and correct as necessary. 3. Check the connector between PS2-relay CN3-relay CN2-SDDB J5 for proper connection and correct as necessary. 4. PS2 I/O check, sensor check • Control signal: SDDB J5-3 (ON) • Location of electrical component: SD-511 3-B 5. M2 operation check • Control signal: SDDB J5-4 to 7 • Location of electrical component: SD-511 3-B 6. Replace M2. 7. Replace SDDB. 8. Replace FSCB. NOTICE • Link to the wiring diagram (N.2.7 SD-511) • Link to the layout drawings for related parts by each trouble code (S.32. C1195)