Description: Imaging unit (C) failure, Imaging unit (M) failure, Imaging unit (Y) failure, Drum/Development unit (K) failure. • All density readings taken from the density pattern produced on the transfer belt are 1.0 g/m2 (IDC sensor photo receiver output) or less during max. density adjustment (Vg/Vdc adjustment). • All density readings taken from the density pattern produced on the transfer belt are 4.0 g/m2 (IDC sensor photo receiver output) and more during max. density adjustment (Vg/Vdc adjustment).
Causes: • Imaging unit/Y,M,C • Drum unit/K • Developing unit/K • IDC sensor/Fr (IDCS/Fr) • IDC sensor/Rr (IDCS/Rr) • MFP board (MFPB) • High voltage unit (HV) • Transfer belt unit
Remedy: 1. Select [Imaging Process Adjustment] -> [Max Image Density Adj] and, if the setting value is negative, readjust. 2. Check the drive transmission portion of the imaging unit or drum/developing unit and correct as necessary. 3. Clean the IDC sensor/Fr (IDCS/Fr) or IDC sensor/Rr (IDCS/Rr) window if dirty. 4. Clean the contact of the imaging unit or drum/developing unit connector if dirty. 5. Check the HV connector for proper connection and correct as necessary. 6. Replace the imaging unit/Y,M,C. 7. Replace the drum unit/K. 8. Replace the developing unit/K. 9. Replace the transfer belt unit. 10. Replace HV. 11. Replace MFPB.