Description: FNS communication error (ENG detection) <bizhub C3851FS> • In the communication between the MFP board (MFPB) and FS control board (FSCB), when the MFP board (MFPB) is receiving data, a communication error is detected. • No finisher is mounted.
Causes: • FS control board(FSCB) • MFP board (MFPB)
Remedy: 1. Turn OFF the main power switch, disconnect and then connect the power cord. Wait for 10 sec. or more after connect the power cord, and turn ON the main power switch. 2. Rewrite the firmware. 3. Check the connector between FSCB CN1-relay CN600-MFPB CN16E for proper connection and correct as necessary. 4. Check the connector between FSCB CN4-relay CN610-DCPU CN11 for proper connection and correct as necessary. 5. FSCB ICP1, ICP2 conduction check 6. Replace FSCB. 7. Replace MFPB.