Description: Fusing sensor wire breaks abnormality (TEM1: edge) • The maximum value and minimum value of detected temperature of fusing temperature sensor/1 (TEM1: edge) is compared after a lapse of given time from starting of warm up and the gap between the value of maximum and minimum is below a given temperature. • The maximum value and minimum value of voltage step of fusing temperature sensor/1 (TEM1: edge) is compared after a lapse of given time from starting of warm up and the gap between the value of maximum and minimum is below a given temperature.
Causes: • Fusing unit • C3922: Fusing temperature sensor/2 (TEM2) • C3925: Fusing temperature sensor/1 (TEM1: center) • C3926: Fusing temperature sensor/1 (TEM1: edge) • DC power supply (DCPS) • MFP board (MFPB)
Remedy: 1. Check the fusing unit for correct installation (whether it is secured in position). 2. Check the open/close operation of the upper right door. 3. Check the fusing unit-MFPB CN13E, DCPS CN2 for proper connection and correct or change as necessary. 4. Replace the fusing unit. 5. Replace MFPB. 6. DCPS F102 conduction check 7. Replace DCPS.