Code: C-0203
Description: Tray /1 up abnormality 2. When the upper limit sensor /1 (PS6) is OFF, PS6 does not turn ON within 20seconds after the tray lift-up motor /1 (M25) turns ON for lifting operation. At this time, an error detection signal is not detected.
Causes: Upper limit sensor /1 (PS6) Tray lift-up motor /1 (M25) Printer control board (PRCB) DC power supply /2 (DCPS /2)
Remedy: 1 Check the paper loaded condition and the rear end restriction plate condition of the tray 1, and repair it if any abnormality. - 2 Check the connector connection and the wiring between PRCB and motor/sensor, and repair it if any abnormality. - 3 Check the I/O drive of the motor and the coupling of the gear, and repair/replace it if any abnormality. 5-F 4 Check I/O and the operation of the sensor, and repair it if any abnormality. 3-G 5 Replace PS6. - 6 Replace M25. - 7 Replace PRCB. - 8 Replace DCPS /2.