Code: C-2802
Description: The maximum density correction (Dmax) is not completed. While in Dmax, the number of rotations of the developing sleeve gets to the maximum.
Causes: Developing motor (M3) Toner control board (TCB) Printer control board (PRCB)
Remedy: 1 Check TCB, and clean it with alcohol if there is IDC sensor dirt or any abnormality. Be sure to clean TCB with alcohol, otherwise replacement of TCB is required. 17-F 2 Check the connector connection and the wiring between PRCB and TCB, and repair it if any abnormality. - 3 Check the I/O drive of the motor and the coupling of the gear, and clean/repair/ replace it if any abnormality. 18-K 4 Replace TCB. - 5 Replace M3. - 6 Replace PRCB.