Code: C-0207
Description: Tray /2 up abnormality 2. When the upper limit sensor /2 (PS10) is OFF, PS10 does not turn ON within 20seconds after the tray lift-up motor /2 (M34) turns ON for lifting operation. At this time, an error detection signal is not detected.
Causes: Upper limit sensor /2 (PS10) Tray lift-up motor /2 (M34) Printer control board (PRCB) DC power supply /2 (DCPS /2)
Remedy: 1 Check the paper loaded condition and the rear end restriction plate condition of the tray 2, and repair it if any abnormality. - 2 Check the connector connection and the wiring between PRCB and motor/sensor, and repair it if any abnormality. - 3 Check the I/O drive of the motor and the coupling of the gear, and repair/replace it if any abnormality. 8-F 4 Check I/O and the operation of the sensor, and repair/replace it if any abnormality. 6-G 5 Replace PS10. - 6 Replace M34. - 7 Replace PRCB. - 8 Replace DCPS /2.