Code: C-2202
Description: Developing motor (M3) speed abnormality. Since an error detection signal is detected a second after M3 turns ON, turn OFF M3 for 0.5seconds. Then, an error detection signal is detected again a second after it is turned ON again.
Causes: Developing motor (M3) Printer control board (PRCB)
Remedy: 1 Check the developing sleeve, and clean/repair it if any abnormality. - 2 Check the connector connection and the wiring between PRCB and the motor, and repair it if any abnormality. - 3 Check the I/O drive of the motor and the coupling of the gear, and repair/replace it if any abnormality. 18-K 4 Replace M3. - 5 Replace PRCB.