Code: C0600
Description: Scanner Motor malfunction
• When the Scanner is at a position other than home, the Scanner Home Sensor does not go from HIGH to LOW even after the lapse of 20 sec. after the Power Switch has been turned ON. • When the Scanner is at the home position, the Scanner Home Sensor does not go from LOW to HIGH even after the lapse of 10 sec. after the Scanner has started its scan motion. • The Scanner Home Sensor does not go from HIGH to LOW even after the lapse of 40 sec. after the Scanner has started its scan motion.
• When the Scanner is at a position other than home, the Scanner Home Sensor does not go from HIGH to LOW even after the lapse of 20 sec. after the Power Switch has been turned ON. • When the Scanner is at the home position, the Scanner Home Sensor does not go from LOW to HIGH even after the lapse of 10 sec. after the Scanner has started its scan motion. • The Scanner Home Sensor does not go from HIGH to LOW even after the lapse of 40 sec. after the Scanner has started its scan motion.
Remedy: 1 Have Scanner motion when it is moved manually. NO Correct drive coupling. Rewind cables. 2 Connectors on the SCP Board properly connected NO Connect. 3 The voltage across PJ11A-12 on the Master Board and GND is DC5V after the malfunction has been reset. NO Change Master Board. 4 The voltage across PJ2F-1 on the SCP Board and GND is DC24V YES Change Scanner Motor and SCP Board. 5 Scanner Home Sensor operation: the voltage across PJ5A-6A on the Master Board and GND is DC0V (sensor blocked) and DC5V (sensor unblocked). YES Change Master Board. NO Change sensor.