Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi C004E — Konica-Minolta Di30

Code: C004E

Description: PU1 Cooling Fan Motor M101, PU2 Cooling Fan Motor M109 Connector left disconnected, defective motor
The LOCK signal is not detected for 5 sec. or more after Power Switch S101 has been turned ON. The LOCK signal is not detected for 5 sec. or more after the motor speed has built up to the constant range.
Remedy: <M101 Drive Check> Check 1. Is the M101 drive voltage being supplied from PWB-B as follows? • The voltage across pins 2 and 1 (M101 ON) of PJ5B on PWB-B should be as follows: When S101 is turned ON (in standby, turning at half speed) ... Approx. DC16V When Start Key is pressed (during a copy cycle, turning at full speed) ... Approx. DC22V Check 2. Is an M101 Lock (abnormal rotation check) signal being output from M101 to PWB-A? • A voltage of DC0V should be developing across pin 25 on PJ3A on PWB-A and GND when M101 is energized. <M109 Drive Check> Check 3. Is an M109 drive voltage of DC24V being supplied from PU-2 as follows? • Once the Power Switch has been turned ON, DC24V should be developing across pins 2 and 1 (GND) of PJ8PU2 on PU2. Check 4. Is an M109 Lock (abnormal rotation check) signal being output from M109 to PWB-A? • A voltage of DC0V should be developing across pin 26 on PJ3A on PWB-A and GND when M109 is energized.

← Xem tất cả mã lỗi Konica-Minolta Di30

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie