Code: SVC E9
Description: OPC marker sensor error
Causes: Marker sensor is not properly detecting mark on OPC belt.
Remedy: 1 Remove photodeveloper cartridge and check for defects. Does photodeveloper appear ok? Go to step 2. Replace photodeveloper cartridge.
2 Observe markers on side. Are belt markers covered with foreign particles? Clean marker area with cotton cloth. If problem persists go to step 3. Go to step 3.
3 Reinstall photodeveloper cartridge. Turn printer off and remove engine controller board shield. See “Engine controller board removal” for steps to remove engine controller board shield. Is cables MCN7 properly connected to engine controller board? Go to step 3. Properly connect cable. If problem persists, go to step 4.
4 Ensure rear cover assembly and front cover assembly are closed. Override top interlock switch and turn printer on. Wait until printer displays error and remove MCN7 from eengine controller board. Check for 5 VDC between MCN7 pin 3 (on engine controller board) and ground (you can touch negative lead of voltmeter to metal frame to obtain ground.) Is voltage present and correct? Engine controller board is providing 5 VDC to OPC sensor. Replace OPC marker sensor. See “Marker sensor assembly removal”. If problem persists, replace engine controller board. See “Engine controller board removal”. Go to step 5.
5 Reconnect MCN7 and disconnect cable from POCN. On disconnected cable, check for 5 VDC on cable pin corresponding to POCN pin 13. You can touch negative lead of voltmeter to metal frame to obtain ground. Is voltage present and correct? LVPS is providing 5 VDC to engine controller board. Replace engine controller board. See “Engine controller board removal”. Go to step 6.
6 Turn printer off. Disconnect cable that connects LVPS ACN1 to engine controller board POCN and check for continuity, shorted pins, or any other cable damage. Is cable ok? Replace LVPS. See “Low voltage power supply (LVPS) with cage removal”. Replace cable.
2 Observe markers on side. Are belt markers covered with foreign particles? Clean marker area with cotton cloth. If problem persists go to step 3. Go to step 3.
3 Reinstall photodeveloper cartridge. Turn printer off and remove engine controller board shield. See “Engine controller board removal” for steps to remove engine controller board shield. Is cables MCN7 properly connected to engine controller board? Go to step 3. Properly connect cable. If problem persists, go to step 4.
4 Ensure rear cover assembly and front cover assembly are closed. Override top interlock switch and turn printer on. Wait until printer displays error and remove MCN7 from eengine controller board. Check for 5 VDC between MCN7 pin 3 (on engine controller board) and ground (you can touch negative lead of voltmeter to metal frame to obtain ground.) Is voltage present and correct? Engine controller board is providing 5 VDC to OPC sensor. Replace OPC marker sensor. See “Marker sensor assembly removal”. If problem persists, replace engine controller board. See “Engine controller board removal”. Go to step 5.
5 Reconnect MCN7 and disconnect cable from POCN. On disconnected cable, check for 5 VDC on cable pin corresponding to POCN pin 13. You can touch negative lead of voltmeter to metal frame to obtain ground. Is voltage present and correct? LVPS is providing 5 VDC to engine controller board. Replace engine controller board. See “Engine controller board removal”. Go to step 6.
6 Turn printer off. Disconnect cable that connects LVPS ACN1 to engine controller board POCN and check for continuity, shorted pins, or any other cable damage. Is cable ok? Replace LVPS. See “Low voltage power supply (LVPS) with cage removal”. Replace cable.