Code: 915
Description: Erase lamp error
Remedy: 1 Turn printer off and remove toner cartridges and photodeveloper cartridge. Check erase lamp cable for proper connection. Is erase lamp cable properly connected? Go to step 2. Properly connect erase lamp. Retest printer. If error clears, problem solved, otherwise go to step 2.
2 Check erase lamp for any visible damage. Is erase lamp damaged? Replace erase lamp. Retest printer. If error clears, problem solved, otherwise remove toner cartridges and photodeveloper cartridge and go to step 3. Go to step 3.
3 Set multimeter to check diodes. Looking at erase lamp through front cover, touch meter positive lead to left LED connection and meter negative lead to right LED connection. LED should illuminate. Check all LEDs on erase lamp board. Do any LEDs fail to illuminate? Replace erase lamp. Retest printer. If error clears, problem solved, otherwise go to step 4. Go to step 4.
4 Remove I/O board shield. Is cable properly connected to I/O board connector DCN15? Go to step 5. Properly connect cable. Retest printer. If error clears, problem solved, otherwise go to step 5.
5 Disconnect cable from erase lamp and DCN15. Check DCN15 pin 11 to erase lamp cable connector pin 1 and DCN15 pin 12 to erase lamp cable connector pin 3 for continuity. Check for shorted pins on both sides of cable. Is cable okay? Replace I/O board. Go to step 6. Replace cable. Retest printer. If error clears, problem solved, otherwise go to step 6.
6 Retest printer. Does error clear? Problem solved. Replace engine controller board.
2 Check erase lamp for any visible damage. Is erase lamp damaged? Replace erase lamp. Retest printer. If error clears, problem solved, otherwise remove toner cartridges and photodeveloper cartridge and go to step 3. Go to step 3.
3 Set multimeter to check diodes. Looking at erase lamp through front cover, touch meter positive lead to left LED connection and meter negative lead to right LED connection. LED should illuminate. Check all LEDs on erase lamp board. Do any LEDs fail to illuminate? Replace erase lamp. Retest printer. If error clears, problem solved, otherwise go to step 4. Go to step 4.
4 Remove I/O board shield. Is cable properly connected to I/O board connector DCN15? Go to step 5. Properly connect cable. Retest printer. If error clears, problem solved, otherwise go to step 5.
5 Disconnect cable from erase lamp and DCN15. Check DCN15 pin 11 to erase lamp cable connector pin 1 and DCN15 pin 12 to erase lamp cable connector pin 3 for continuity. Check for shorted pins on both sides of cable. Is cable okay? Replace I/O board. Go to step 6. Replace cable. Retest printer. If error clears, problem solved, otherwise go to step 6.
6 Retest printer. Does error clear? Problem solved. Replace engine controller board.