Code: 120-04...120-07
Description: Fuser Error
An error has occurred in the fuser.
An error has occurred in the fuser.
Remedy: 1 Check the input voltage switch on the back of the low volt power supply (LVPS). Is the voltage level (115/230) properly set? Go to step 2. Set switch for proper country voltage.
2 Turn the printer off and remove the rear cover. Check connector JFUSER1 for proper connection to system card, cable for pinch points and cable or connector for any other damage. Is cable properly connected and damage free? Go step 3. If connector is damaged on system card, replace system card. Go to “System card removal”. If fuser cable is damaged, replace cable.
3 Remove fuser. Go to “Fuser removal”. Check AC and DC auto-connects on both the fuser and the printer for damage. Are connectors free of damage? Go to step 4. If connector is damaged on fuser, replace fuser. If either of the cable connectors are damaged, replace the appropriate cable.
4 Check for the following continuity between DC auto-connect and FUSER1. Is continuity present? DC auto-connect JFUSER1 pin 9 pin 9 pin 10 pin 10 Go to step 5. Replace DC fuser cable.
5 Check for continuity between the following pins of the AC auto-connect and the pins of the connector that connects to the LVPS. Is continuity present? LVPS connector AC auto-connect pin 1 pin 5 pin 2 pin 4 pin 3 pin 1 Go to step 6. Replace AC fuser cable.
6 Reinstall fuser. Go to “Fuser removal”. Does error clear? Problem solved. Go to step 7.
7 Replace fuser. Go to “Fuser removal”. Does error clear? Problem solved. Replace system card. Go to “System card removal”.
2 Turn the printer off and remove the rear cover. Check connector JFUSER1 for proper connection to system card, cable for pinch points and cable or connector for any other damage. Is cable properly connected and damage free? Go step 3. If connector is damaged on system card, replace system card. Go to “System card removal”. If fuser cable is damaged, replace cable.
3 Remove fuser. Go to “Fuser removal”. Check AC and DC auto-connects on both the fuser and the printer for damage. Are connectors free of damage? Go to step 4. If connector is damaged on fuser, replace fuser. If either of the cable connectors are damaged, replace the appropriate cable.
4 Check for the following continuity between DC auto-connect and FUSER1. Is continuity present? DC auto-connect JFUSER1 pin 9 pin 9 pin 10 pin 10 Go to step 5. Replace DC fuser cable.
5 Check for continuity between the following pins of the AC auto-connect and the pins of the connector that connects to the LVPS. Is continuity present? LVPS connector AC auto-connect pin 1 pin 5 pin 2 pin 4 pin 3 pin 1 Go to step 6. Replace AC fuser cable.
6 Reinstall fuser. Go to “Fuser removal”. Does error clear? Problem solved. Go to step 7.
7 Replace fuser. Go to “Fuser removal”. Does error clear? Problem solved. Replace system card. Go to “System card removal”.