Code: 141.xx
Description: Service Staging Motor
Staging motor error.
Staging motor error.
Remedy: 1 Turn the printer off, and then remove the rear shield. See “Rear shield removal”. Check the cable at JSP1 on the controller board for proper connection. Is the cable properly connected? Go to step 3. Properly connect the cables, and POR the printer. Go to step 2.
2 Did the printer function correctly after reconnecting the cables? Problem resolved. Go to step 3.
3 Turn the printer on, and then verify the following approximate values at JSP1: Are the values approximately correct? Replace the autocompensator mechanism. See “Autocompensator mechanism (ACM) removal—standard tray”. Replace the controller board. See “Controller board removal”.
2 Did the printer function correctly after reconnecting the cables? Problem resolved. Go to step 3.
3 Turn the printer on, and then verify the following approximate values at JSP1: Are the values approximately correct? Replace the autocompensator mechanism. See “Autocompensator mechanism (ACM) removal—standard tray”. Replace the controller board. See “Controller board removal”.