Code: 122.05
Description: Service Fuser Error
Fuser failed to reach final temperature in time.
Fuser failed to reach final temperature in time.
Remedy: 1 Check the clearance around the printer. See “Clearances” or check the chart below: Does the error clear? Problem resolved. Make sure the proper clearance is maintained.
2 Check the fuser connections on the fuser, at JFUSES1 on the controller board, and the AC connection at the LVPS. Are the connections correct? Replace the fuser. See “Fuser assembly removal”. Problem resolved.
3 Turn the printer on, and then check the following values at JFUSES1. Are these values approximately correct? Replace the fuser assembly. See “Fuser assembly removal”. Replace the controller board. See “Controller board removal”.
2 Check the fuser connections on the fuser, at JFUSES1 on the controller board, and the AC connection at the LVPS. Are the connections correct? Replace the fuser. See “Fuser assembly removal”. Problem resolved.
3 Turn the printer on, and then check the following values at JFUSES1. Are these values approximately correct? Replace the fuser assembly. See “Fuser assembly removal”. Replace the controller board. See “Controller board removal”.