Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi 122.14 — Lexmark C544dtn

Code: 122.14

Description: Service Fuser Error
Fuser shorted thermistor check failed for hot roll thermistor.
Remedy: 1 Some low-voltage power supply FRUs have a voltage selector switch. If it does, the switch needs to be set to the correct voltage for your area. Has the LVPS been changed? Check the switch on the side of the LVPS to verify the correct voltage is set. Go to step 2.
2 Turn the printer off, and remove the rear shield. See “Rear shield removal”. Check the cable at JFUSES1 for proper connection to the controller board, the cable for pinch points, and the cable or connector for any other damage. Is the cable damaged? Replace the fuser cable. Go to step 3.
3 Check the connector JLVPS1 for proper connection to the controller board, the cable for pinch points, and the cable or connector for any other damage. Is the cable damaged? Repair or replace the LVPS cable. Go to step 4.
4 Check the power cable on the left side of the fuser and the thermistor cables and connections on the right side of the fuser. Are the cables or connectors damaged? Repair the cables. If the cables cannot be repaired, replaced the fuser. See “Fuser assembly removal”. Go to step 5.
5 Check the following values at JFUSES1: Are the values approximately correct? Go to step 6. Replace the controller board. See “Controller board removal”.
6 Replace the fuser. See “Fuser assembly removal”. Does the error clear? Problem resolved. Replace the controller board. See “Controller board removal”.

← Xem tất cả mã lỗi Lexmark C544dtn

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie