Code: 917.xx
Description: Service Transfer Roll
There is a problem with the transfer roll.
There is a problem with the transfer roll.
Remedy: 1 Turn the printer off, and remove the rear shield. See “Rear shield removal”. Turn the printer on, and check the cable at JHVPS1 connector on the controller board without disconnecting it. Verify the following values: Are the values approximately correct? Replace the HVPS. See “High-voltage power supply (HVPS) assembly removal”. If the problem persists, go to step 2. Replace the controller board. See “Controller board removal”.
2 Turn the printer off, and remove the ITU. See “Image transfer unit (ITU) removal”. Check the three spring-loaded contacts between the HVPS and the ITU located at the left rear of the printer and above the HVPS. Are the contact dirty?. Clean the contacts, and reinstall the ITU. Replace the ITU. See “Image transfer unit (ITU) removal”.
2 Turn the printer off, and remove the ITU. See “Image transfer unit (ITU) removal”. Check the three spring-loaded contacts between the HVPS and the ITU located at the left rear of the printer and above the HVPS. Are the contact dirty?. Clean the contacts, and reinstall the ITU. Replace the ITU. See “Image transfer unit (ITU) removal”.