Code: 911, 912
Description: 911 DC Motor (2) Locking error - the motor did not stabilize. 912 DC Motor The motor stabilized then locking was released.
Remedy: 1 Fuser Block Assembly Check the paper feed parts in the fuser drive assembly for excessive noise or vibration. Look for loose or worn paper feed parts. • If problems exist, repair or replace the fuser block assembly. • If excessive noise or vibrations exis2 Developer/Paper Feed Motor Assembly (M2) Developer/Paper Feed Motor Cable Engine Board Check the voltages on connector CON 1 on the developer/paper feed motor board. All voltages are approximate values: Pin # Voltage Motor Running Motor Static 1 CS 0 V dc +5 V dc 2 ROIR 0 V dc 0 V dc 3 GND 0 V dc 0 V dc 4 +5 V dc +5 V dc +5 V dc 5 Lo 0 V dc +5 V dc 6 P/S 0 V dc +5 V dc 7 PGND 0 V dc 0 V dc 8 PGND 0 V dc 0 V dc 9 +24 V dc +24 V dc +24 V dc 10 +24 V dc +24 V dc +24 V dc If the voltage on pin 4, 9 or 10 are incorrect, check continuity of the cable. • If correct, disconnect CON 1 from the board assembly and check the voltages on the cable connector. • If incorrect, check continuity of the cable. • If incorrect, replace the cable. • If correct, replace the engine board. • If the voltages on the cable connector are correct, replace the developer/ paper feed motor assembly. If the voltages on pins 1, 5 and 6 always measure approximately +5 V dc, replace the developer/paper feed motor assembly. If the voltages always measure approximately 0 V dc, check the continuity of the cable. • If incorrect, replace the cable. • If correct, replace the engine board assembly.t in the motor assembly, replace the developer/ paper feed motor assembly. • If no problem is located for paper feed parts, the problem may be the engine board assembly.