Code: 922
Description: 922 Fuser Error Indicates that the fuser temperature failed to increase.
Remedy: 1 Fuser Assembly Fuser Lamp Circuit Be sure the fuser assembly is correctly installed and locked down. Disconnect the AC power cord from the printer. Disconnect CN406 from the LVPS board and check for continuity between pins 1 and 2 on the CN406 cable connector. • If incorrect, go to step 2. • If correct, check the voltage between CN406 Pin 1 and 2. The voltage should read the same as the AC line voltage. • If incorrect replace the LVPS. 2 Fuser Lamp Thermostat Fuser Lamp Contacts Remove the fuser assembly from the printer. Note: Take care not to damage any pins when checking continuity. Check continuity between the two outer fuser lamp contacts of the autoconnector (HCU cable) located on the bottom of the fuser assembly. • If correct, go to step 3. • If incorrect, check the fuser lamp, thermostat, fuser lamp contacts and HCU cable, replacing any defective parts. 3 Interlock Switches Go to the “Cover Interlock Service Check”.