Code: 910
Description: Developing Motor Error (DM)
This error indicates that the developing motor (DM) drive may have a problem.
This error indicates that the developing motor (DM) drive may have a problem.
Remedy: 1 • Toner Cartridge • Developer Gear Unit • Developer Motor If any unusual rotation noise is heard while printing, check the toner cartridge and replace, if necessary. If the noise continues after the toner cartridge is replaced, check the developer gear unit by manually turning the motor. • If any damage to the gears is found, replace the developer gear drive unit. • If the noise continues, replace the developer drive motor (DM).
2 Cable and Connectors If the developer motor does not turn On: • Ensure the connector DCN9 on the IOD1 P.W.B. board and the connector for the developer motor are completely connected. • Ensure connectors DCN1 on the IOD1 and 11CN on the main engine (MCTL P.W.B.) board are completely connected. • Replace any damaged parts.
3 Developer Motor (DM) Check for +24V between DM1-4 and DM1-6 • DCN9-4 and DCN9-6 • DCN10-3 and DCN10-4 Check for +5V between DM1-5 and DM1-9 • DCN9-5 and DCN9-9 • DCN10-7 and DCN-9 If either +24V or +5V is found while checking these connectors, replace the developer motor (DM).
4 • IOD2 P.W.B. Board • IOD1 P.W.B. Board • Main Engine (MCTL P.W.B.) Board If after replacing the developer motor the problem still exists, replace in the following order until the problem is resolved: • IOD2 P.W.B. board • IOD1 P.W.B. board • Main engine (MCTL P.W.B.) board
2 Cable and Connectors If the developer motor does not turn On: • Ensure the connector DCN9 on the IOD1 P.W.B. board and the connector for the developer motor are completely connected. • Ensure connectors DCN1 on the IOD1 and 11CN on the main engine (MCTL P.W.B.) board are completely connected. • Replace any damaged parts.
3 Developer Motor (DM) Check for +24V between DM1-4 and DM1-6 • DCN9-4 and DCN9-6 • DCN10-3 and DCN10-4 Check for +5V between DM1-5 and DM1-9 • DCN9-5 and DCN9-9 • DCN10-7 and DCN-9 If either +24V or +5V is found while checking these connectors, replace the developer motor (DM).
4 • IOD2 P.W.B. Board • IOD1 P.W.B. Board • Main Engine (MCTL P.W.B.) Board If after replacing the developer motor the problem still exists, replace in the following order until the problem is resolved: • IOD2 P.W.B. board • IOD1 P.W.B. board • Main engine (MCTL P.W.B.) board