Code: 920.07
Description: POST Error
Narrow media sensor not connected.
Narrow media sensor not connected.
Remedy: 1 Turn the printer off, and then remove the rear frame cover. See “Rear frame cover removal”. Reseat the cable in connector JTRAY1. Does the error clear? Problem resolved. Go to step 2.
2 Check the cable in connector JTRAY1 for pinch points and the cable or connector for any other damage. Is the cable damaged? Replace the paper pick mechanism. See “Paper pick mechanism assembly removal”. Go to step 3.
3 POR the printer. Place a voltmeter between JTRAY1, pin 4, and ground (pin 1). Does the meter read 5 V dc? Go to step 4. Replace the system board. See “System board removal”.
4 1. Disconnect the cable in JTRAY1. 2. Connect the cable from the new paper pick mechanism. 3. Bring the printer up in Diagnostic menu (turn off the printer, press and hold and . and turn on the printer). 4. Select SENSOR TESTS, and press Select( ). 5. Select Dynamic Sensors, and press Select( ). 6. Select Narrow Media, and press Select( ). 7. Activate the narrow media sensor. Did the narrow media sensor change from Closed to Open? Remove the paper pick mechanism. See “Paper pick mechanism assembly removal”. Replace the system board. See “System board removal”.
2 Check the cable in connector JTRAY1 for pinch points and the cable or connector for any other damage. Is the cable damaged? Replace the paper pick mechanism. See “Paper pick mechanism assembly removal”. Go to step 3.
3 POR the printer. Place a voltmeter between JTRAY1, pin 4, and ground (pin 1). Does the meter read 5 V dc? Go to step 4. Replace the system board. See “System board removal”.
4 1. Disconnect the cable in JTRAY1. 2. Connect the cable from the new paper pick mechanism. 3. Bring the printer up in Diagnostic menu (turn off the printer, press and hold and . and turn on the printer). 4. Select SENSOR TESTS, and press Select( ). 5. Select Dynamic Sensors, and press Select( ). 6. Select Narrow Media, and press Select( ). 7. Activate the narrow media sensor. Did the narrow media sensor change from Closed to Open? Remove the paper pick mechanism. See “Paper pick mechanism assembly removal”. Replace the system board. See “System board removal”.