Code: 168.xx
Description: Motor Error
HCIT elevator motor error
HCIT elevator motor error
Remedy: 1 Is the paper properly loaded in the highcapacity input tray (HCIT)? Go to step 2. Fan the media, and then stack flat in the HCIT drawer.
2 1. Turn the printer off. 2. Reseat option the HCIT option. 3. Bring the printer up in Diagnostics Menu (turn off the printer, press and hold and . and turn on the printer). 4. Select PRINT TESTS, and press Select( ). 5. Select HCIT, and press Select( ). 6. Select Single, and press Select( ). Did the error clear? Problem resolved. Go to step 3.
3 1. Turn the printer off. 2. ,Remove the rear frame cover. See “Rear frame cover removal”. 3. Check the option cable in connector JOPT1 (A) on the system board for proper connection, for cable pinch points, and for any other damage to the cable or connector Is the cable damaged? Replace the option cable. See “Option cable removal”. Go to step 4.
4 Check the cable in the HCIT. Is the cable damaged? Replace the elevator-up cable. Replace the elevator motor with sensor. See “HCIT elevator motor with sensor removal”.
2 1. Turn the printer off. 2. Reseat option the HCIT option. 3. Bring the printer up in Diagnostics Menu (turn off the printer, press and hold and . and turn on the printer). 4. Select PRINT TESTS, and press Select( ). 5. Select HCIT, and press Select( ). 6. Select Single, and press Select( ). Did the error clear? Problem resolved. Go to step 3.
3 1. Turn the printer off. 2. ,Remove the rear frame cover. See “Rear frame cover removal”. 3. Check the option cable in connector JOPT1 (A) on the system board for proper connection, for cable pinch points, and for any other damage to the cable or connector Is the cable damaged? Replace the option cable. See “Option cable removal”. Go to step 4.
4 Check the cable in the HCIT. Is the cable damaged? Replace the elevator-up cable. Replace the elevator motor with sensor. See “HCIT elevator motor with sensor removal”.