Code: 920.19
Description: POST Error
Stepper motor not connected.
Stepper motor not connected.
Remedy: 1 Turn the printer off, and then remove the rear frame cover. See “Rear frame cover removal”. Reseat the motor driver cable in connector JDVR1 (A). Does the error clear? Problem resolved. Go to step 2.
Remove the right cover. See “Right cover removal”. Check the motor driver cable in connector JDVR1 on the system board for pinch points or any other damage to the cable or connector. Also check the connector on the motor drive card. Is the cable damaged? Replace the motor driver cable. See “Motor driver cable removal”. Go to step 3.
3 Measure the resistance across fuses F12 (A) and F13 (B)on the system board. Is either fuse blown? Replace the system board. See “System board removal”. Go to step 4.
4 Check the transport motor cable for pinch points and any other damage to the cable or connector. Is the cable damaged? Replace the transport motor cable. See “Transport cable removal”. Go to step 5.
5 Visually inspect the motor driver card. Is the motor driver card damaged? Replace the motor driver card. See “Motor driver card removal”. Go to step 6.
6 Replace the EP drive assembly. See “Electrophotographic (EP) drive assembly removal”. Problem resolved. Replace the system board. See “System board removal”.
Remove the right cover. See “Right cover removal”. Check the motor driver cable in connector JDVR1 on the system board for pinch points or any other damage to the cable or connector. Also check the connector on the motor drive card. Is the cable damaged? Replace the motor driver cable. See “Motor driver cable removal”. Go to step 3.
3 Measure the resistance across fuses F12 (A) and F13 (B)on the system board. Is either fuse blown? Replace the system board. See “System board removal”. Go to step 4.
4 Check the transport motor cable for pinch points and any other damage to the cable or connector. Is the cable damaged? Replace the transport motor cable. See “Transport cable removal”. Go to step 5.
5 Visually inspect the motor driver card. Is the motor driver card damaged? Replace the motor driver card. See “Motor driver card removal”. Go to step 6.
6 Replace the EP drive assembly. See “Electrophotographic (EP) drive assembly removal”. Problem resolved. Replace the system board. See “System board removal”.