Remedy: 1 Turn the printer off, and then remove the rear frame cover. See “Rear frame cover removal”. Check the cable in connector JFAN1 (A) for proper connection to the system board, for pinch points, and for any other damage to the cable or the connector. Is the cable damaged? Replace the fan. See “Cooling fan removal”. Go to step 2. 2 Measure the resistance across fuse F5 on the system board. Is the fuse blown? Replace the system board. See “System board removal”. Go to step 3. 3 1. Disconnect the cable in connector JFAN1, and connect a new fan. 2. Bring the printer up in Diagnostic menu (turn off the printer, press and hold and . and turn on the printer). Did the error clear? Replace the cooling fan. See “Cooling fan removal”. Replace the system board. See “System board removal”.