Code: 920.17
Description: POST Error
Output bin cable not connected.
Output bin cable not connected.
Remedy: 1 Turn the printer off, and then remove the rear frame cover. See “Rear frame cover removal”. Reseat the bin full sensor cable in connector JBIN1 (A). Does the error clear? Problem resolved. Go to step 2.
2 Check the bin full sensor cable in connector JBIN1 for pinch points and any other damage to the cable or connector. Is the cable damaged? Replace the bin full sensor with cable. See “Bin full sensor removal”. Go to step 3.
3 1. Disconnect the cable in the JBIN1 connector. 2. Connect the new bin full flag cable in the JBIN connector. 3. Bring the printer up in Diagnostic menu (turn off the printer, press and hold and . and turn on the printer). 4. Select SENSOR TESTS, and press Select( ). 5. Select Other Sensors, and press Select( ). 6. Select Bin Full Test, and press Select( ). 7. Activate the new bin full sensor by placing a sheet of paper in the sensor. Did the bin full sensor change from Open to Closed? Replace the bin full sensor and cable. See “Bin full sensor removal”. Replace the system board. See “System board removal”.
2 Check the bin full sensor cable in connector JBIN1 for pinch points and any other damage to the cable or connector. Is the cable damaged? Replace the bin full sensor with cable. See “Bin full sensor removal”. Go to step 3.
3 1. Disconnect the cable in the JBIN1 connector. 2. Connect the new bin full flag cable in the JBIN connector. 3. Bring the printer up in Diagnostic menu (turn off the printer, press and hold and . and turn on the printer). 4. Select SENSOR TESTS, and press Select( ). 5. Select Other Sensors, and press Select( ). 6. Select Bin Full Test, and press Select( ). 7. Activate the new bin full sensor by placing a sheet of paper in the sensor. Did the bin full sensor change from Open to Closed? Replace the bin full sensor and cable. See “Bin full sensor removal”. Replace the system board. See “System board removal”.