Code: 120.00...120.21
Description: Fuser Error
An error has occurred in the fuser.
An error has occurred in the fuser.
Remedy: 1 Check the input voltage switch on the back of the low-voltage power supply (LVPS). Note: Some LVPS FRU do not have switches and switch automatically. If your does not have a switch, go to step 2. Is the voltage level (115 V/230 V) properly set? Go to step 2. Set the switch for the proper country voltage.
2 1. Remove the fuser. See “Fuser removal”. 2. Check the AC and DC autoconnects on both the fuser and the printer for damage. Are the connections damaged? Replace the appropriate cable. See “Fuser AC cable removal” or “Fuser DC cable removal”. Go to step 3.
3 Replace the fuser. See “Fuser removal”. Does the error clear? Problem resolved. Go to step 4.
4 Remove the rear frame cover. See“Rear frame cover removal”. Check the cable in connector JFUSER1 (A) (fuser DC cable) for proper connection to the system board, the cable for pinch points, and the cable or connector for any other damage. Is the cable damaged? Replace the fuser DC cable.See “Fuser DC cable removal”. Go to step 5.
5 Check the cable in connector JLVPS2 (A) for proper connection to the system board, the cable for pinch points, and the cable or connector for any other damage. Is the cable damaged? Replace the LVPS. See “Low-voltage power supply (LVPS) removal”. Go to step 6.
6 Measure the resistance across fuse F6 on the system board. Is the fuse blown? Replace the system board. See “System board removal”. Go to step 7.
7 Check for the following continuity between the DC autoconnect JFUSER1 on the system board. Is continuity present? Go to step 8. Replace the fuser DC cable. See “Fuser DC cable removal”.
8 Check for continuity between the following pins of the AC autoconnect and the pins of the connector that connects to the LVPS. Is continuity present? Replace the system board. See “System board removal”. Replace the fuser AC cable. See “Fuser AC cable removal”.
2 1. Remove the fuser. See “Fuser removal”. 2. Check the AC and DC autoconnects on both the fuser and the printer for damage. Are the connections damaged? Replace the appropriate cable. See “Fuser AC cable removal” or “Fuser DC cable removal”. Go to step 3.
3 Replace the fuser. See “Fuser removal”. Does the error clear? Problem resolved. Go to step 4.
4 Remove the rear frame cover. See“Rear frame cover removal”. Check the cable in connector JFUSER1 (A) (fuser DC cable) for proper connection to the system board, the cable for pinch points, and the cable or connector for any other damage. Is the cable damaged? Replace the fuser DC cable.See “Fuser DC cable removal”. Go to step 5.
5 Check the cable in connector JLVPS2 (A) for proper connection to the system board, the cable for pinch points, and the cable or connector for any other damage. Is the cable damaged? Replace the LVPS. See “Low-voltage power supply (LVPS) removal”. Go to step 6.
6 Measure the resistance across fuse F6 on the system board. Is the fuse blown? Replace the system board. See “System board removal”. Go to step 7.
7 Check for the following continuity between the DC autoconnect JFUSER1 on the system board. Is continuity present? Go to step 8. Replace the fuser DC cable. See “Fuser DC cable removal”.
8 Check for continuity between the following pins of the AC autoconnect and the pins of the connector that connects to the LVPS. Is continuity present? Replace the system board. See “System board removal”. Replace the fuser AC cable. See “Fuser AC cable removal”.