Code: 920.12
Description: POST Error
One toner sensor is not connected.
One toner sensor is not connected.
Remedy: 1 Remove the left cover. See “Left cover removal”. Check all the toner level sensor cables connected to the rear of the HVPS. Are any of the cables damaged? Replace the damaged sensor. See “Toner level sensor removal”. Go to step 2.
2 Disconnect the cable in the connector JHVPS1 from the system board and the HVPS. Check for the following continuity. Is continuity present? Go to step 3. Replace the HVPS cable. See “High-voltage power supply (HVPS) cable removal”
3 Reconnect the HVPS cable. Disconnect one of the toner level sensors and POR the printer. Does the 920.12 error occur again? Replace the toner level sensor. See “Toner level sensor removal”. Repeat the step for the other toner level sensors. After all the sensors are tested without the 920.12 recurring, the problem is resolved.
2 Disconnect the cable in the connector JHVPS1 from the system board and the HVPS. Check for the following continuity. Is continuity present? Go to step 3. Replace the HVPS cable. See “High-voltage power supply (HVPS) cable removal”
3 Reconnect the HVPS cable. Disconnect one of the toner level sensors and POR the printer. Does the 920.12 error occur again? Replace the toner level sensor. See “Toner level sensor removal”. Repeat the step for the other toner level sensors. After all the sensors are tested without the 920.12 recurring, the problem is resolved.