Code: 920.11
Description: POST Error
Two toner sensors are not connected.
Two toner sensors are not connected.
Remedy: 1 Remove the left cover. See “Left cover removal”. Check all the toner level sensor cables connected to the rear of the HVPS. Are any of the cables damaged? If only one of the toner level sensor is damaged: • Disconnect the sensor. • Go to step 6.’ If two toner level sensors are damaged, replace the damaged sensors. See “Toner level sensor removal”. Go to step 2.
2 Reconnect the HVPS cable. Disconnect one of the toner level sensors and POR the printer. Does the 920.11 error occur again? • If the error recurrs, then this sensor is one of the bad sensors.’ • Continue disconnecting the toner level sensors until two sensors are disconnected and the 920.11 error occurs. • Replace the toner level sensors that are disconnected. See “Toner level sensor removal”. Repeat this step for the other toner level sensors until the 920.11.
2 Reconnect the HVPS cable. Disconnect one of the toner level sensors and POR the printer. Does the 920.11 error occur again? • If the error recurrs, then this sensor is one of the bad sensors.’ • Continue disconnecting the toner level sensors until two sensors are disconnected and the 920.11 error occurs. • Replace the toner level sensors that are disconnected. See “Toner level sensor removal”. Repeat this step for the other toner level sensors until the 920.11.