Code: 920.25
Description: POST Error
Bad temperature and humidity sensor.
Bad temperature and humidity sensor.
Remedy: 1 Open the front access door. Reseat the transport cable. Does the error clear? Problem resolved. Go to step 2.
2 Turn the printer off, and then remove the rear frame cover. See “Rear frame cover removal”. Reseat the transport cable in connector JTPS1 (A). Does the error clear? Problem resolved. Go to step 3.
3 Check the transport cable in connector JTPS1 for pinch points and for any other damage to the cable or connector. Is the cable damaged? Replace the transport cable. See “Transport cable removal”. Go to step 4.
4 Check the continuity at JTPS1, pins 1–10). Is there continuity? Go to step 5. Replace the cartridge motor1/fuser motor cable. See “Cartridge motor 1/ fuser cable removal”.
5 Replace the transport belt assembly. See “Transfer module removal”. Does the error clear? Problem resolved. Replace the system board. See “System board removal”.
2 Turn the printer off, and then remove the rear frame cover. See “Rear frame cover removal”. Reseat the transport cable in connector JTPS1 (A). Does the error clear? Problem resolved. Go to step 3.
3 Check the transport cable in connector JTPS1 for pinch points and for any other damage to the cable or connector. Is the cable damaged? Replace the transport cable. See “Transport cable removal”. Go to step 4.
4 Check the continuity at JTPS1, pins 1–10). Is there continuity? Go to step 5. Replace the cartridge motor1/fuser motor cable. See “Cartridge motor 1/ fuser cable removal”.
5 Replace the transport belt assembly. See “Transfer module removal”. Does the error clear? Problem resolved. Replace the system board. See “System board removal”.