Code: 920.05
Description: POST Error
Printhead motor not connected
Printhead motor not connected
Remedy: 1 1. Turn the printer off. 2. Remove the rear frame cover. See “Rear frame cover removal”. 3. Reseat the cables in connector JMIRR1 (A). Does the error clear? Problem resolved. Go to step 2.
2 Check the cables in connector JMIRR1 for pinch points and any other damage to the cables or connectors. Is the cable damaged? Replace the printhead. See “Printhead removal, installation, and adjustment”. Go to step 3.
3 Measure the resistance across fuse F6 (A) on the system board. Is the fuse blown? Replace the system board. See “System board removal”. Go to step 4.
4 1. Perform the printhead verification to check whether the new printhead solves the problem. See “Printhead verification”. 2. Select PRINTHEAD TESTS, and press Select( ). 3. Select Mirror Motor Test, and press Select ( ). Did the mirror motor pass the test? Replace the printhead. See “Printhead removal, installation, and adjustment”. Replace the system board. See “System board removal”.
2 Check the cables in connector JMIRR1 for pinch points and any other damage to the cables or connectors. Is the cable damaged? Replace the printhead. See “Printhead removal, installation, and adjustment”. Go to step 3.
3 Measure the resistance across fuse F6 (A) on the system board. Is the fuse blown? Replace the system board. See “System board removal”. Go to step 4.
4 1. Perform the printhead verification to check whether the new printhead solves the problem. See “Printhead verification”. 2. Select PRINTHEAD TESTS, and press Select( ). 3. Select Mirror Motor Test, and press Select ( ). Did the mirror motor pass the test? Replace the printhead. See “Printhead removal, installation, and adjustment”. Replace the system board. See “System board removal”.