Code: 201
Description: Primary: Media has jammed at or before the fuser sensor. Open the printer lower right or center door to access the jammed media. Secondary: If sheets have been accumulated to be stapled when the jam is detected, the printer alternately flashes the primary and secondary messages indicating the accumulated sheets should not be removed during jam clearing. Note: When the secondary message is displayed, if the accumulated sheets are removed the printer will not reprint these sheets. Also if the print job is completed, the portion of the job printed after the jam will not be stapled.
Remedy: 1 Remove fuser from printer, remove oiler housing from fuser, and pivot the paper guide up. Is paper jammed inside the fuser? Clear the jam. Go to step 2 2 Check fuser entry guide for toner buildup. Is toner built up on the fuser entry guide? Replace the “Fuser assembly” on page A-35. Go to step 3 3 Check fuser exit sensor flag. Does the flag rotate freely and return to normal position when released? Go to step 4 Replace the “Fuser assembly” on page A-35. 4 Reinstall fuser and perform the “BASE SENSOR TEST”. Note: Use a spring hook to actuate the flag. Does fuser exit sensor pass test? Go to step 5 Perform the following in order: 1. Reseat the connector J33 on the system board. 2. Replace the “Fuser assembly”. 3. Replace the “LVPS assembly”. 4. Replace the “System board”. 5 Check the vacuum transport belts (VTB) for motion. Observe the belt through the front door. Are the belts on the VTB assembly turning? Go to step 6 Go to “Vacuum transport belt (VTB)” to verify correct installation. 6 Check the VTBs for wear or damage. Are the belts worn or damaged? Replace the “Vacuum transport belt (VTB)”. Go to step 7. 7 Check the VTB plate for a buildup of debris. Is there a debris buildup? Clean off the VTB plate. Go to step 8 8 Does media move smoothly into the fuser from the VTB? Call the next level of support. Replace the “Vacuum transport belt (VTB) fan”.