Code: 129
Description: Fuser Error Fuser under temperature in standby - BUR.
Remedy: 1 Turn the printer on and allow it to reach a Ready prompt. Note: The printer may not complete POR and continues to display the 129 Error message. Remove the fuser assembly from the printer. Measure the voltage on connector J33-7 on the system board. The voltage should measure approximately +3.3 V dc. Is the voltage correct? Go to step 2 Replace the “System board”. 2 Measure the voltage on the fuser DC control connector on the LVPS. Measure the voltage on pin 7 of the connector. Does the voltage measure approximately +3.3 V dc. Replace the“Fuser assembly”. Replace the “LVPS assembly”.