Code: 125
Description: Fuser Error Fuser over temperature - BUR. Error code 125 displays whenever the printer detects a problem with the fuser running over temperature or the fuser lamps have been on too long. A problem exists in the fuser assembly with the back up roll bearings, back up roll thermistor, LVPS, or system board.
Remedy: 1 Open the right fuser access door. Observe the fusser and see if the backup roll fuser lamp turns on and off. You may have to observe for a few minutes. Does the lamp turn off and on? Go to step 2 Replace the “LVPS assembly”. 2 Turn the printer on and measure the voltage on connector J33-12 on the system board. The voltage should measure approximately +0.13 V ac to +0.64 V ac as the backup roll lamp turns on and off. Is the voltage correct? Replace the “Fuser assembly”. Replace the “System board”.