Code: 127
Description: Fuser Error Fuser open thermistor BUR. Backup roll thermistor or thermistor circuits are open If error code 127 displays the printer detects a problem in the fuser hot roll or back up roll fuser lamp circuits, fuser hot roll thermistor, back up roll thermistor, system board, or LVPS fuser control circuits.
Remedy: 1 Turn the printer on and allow it to reach the Ready prompt. Note: The printer may not complete POR and post a 127 Error message. Measure the voltage on connector J33-7 on the system board. The voltage should measure approximately +3.3 V dc. Is the voltage correct? Go to step 2 Replace the “System board”. 2 Measure the voltage on the fuser DC control connector on the LVPS. Measure the voltage on pin 7 of the connector. Is the voltage measure approximately +3.3 V dc. Replace the “Fuser assembly”. Replace the “LVPS assembly”